CC monster motor diameter

[himalaya]

CC website says the motor in the MMM combo will be 75mm long for 2200KV and 67mm for 2650KV. So how is the diameter? and the shaft length? I looked carefully for that info but not found.

I am running a Tekno Losi 8-T, I think it might be wise to prepare another properly sized motor mount for my coming MMM combo.

Thanks. :gasp:

[Sammus]

It is based on NEU motors, 5mm shaft diameter and presumabley 44mm diameter (with cooling fins), like the finned neumotors.

[himalaya]

Good, but the CC motor can looks more like "ribbed" or slotted than "finned". The neumotors really have fins.
So which neu motor should I compare CC motor with? Smooth can (39.5mm) or Finned can(44mm)? IMO it's more like the smooth can version, otherwise the motor wall will be 3~4mm thick! and weights a lot.

[Arct1k]

I just got the calipers out:

44mm Neu
42mm castle ribbed
48mm castle hpi version

Rgds

[phatmonk]

Arkt1c where did you get that CC/HPI version?

[Arct1k]

;-) - I'd have to shoot you

[himalaya]

I just got the calipers out:

44mm Neu
42mm castle ribbed
48mm castle hpi version

Rgds

Thanks Buddy. Great Info.
But were your calipers precise enough to have a 0.1mm reading resolution?:whistle:

[Arct1k]

yes... but are you that tight on spacing

[brushlessboy16]

Thanks Buddy. Great Info.
But were your calipers precise enough to have a 0.1mm reading resolution?:whistle:

Mine can :)
my cc neu came out to 42.02mm :P

[himalaya]

Mine can :)
my cc neu came out to 42.02mm :P

Thanks! this data really helps.

Hi Arct1k, I am running a Tekno converted Losi 8T, I have to confirm the motor will fit into the motor mount fluently. Also I need to know the gap size beteen the motor can and the motor mount to find a proper way to do thermal coupling for the mount acts as heatsink as well...... Thanks for your data.:yes: