PDA

View Full Version : esc for 8L feigo

tyrewq
12.10.2005, 09:15 PM
could this esc run the 8L, while using 6 gp3300? i don't know how amp could affect the motor
Sylvester
12.10.2005, 09:31 PM
what esc?
tyrewq
12.10.2005, 09:35 PM
http://cgi.ebay.com/RC-Smart-30A-Brushless-Motor-Speed-Controller-ESC-05UKP_W0QQitemZ6018578865QQcategoryZ19164QQrdZ1QQc mdZViewItem

if the link doesnt work try 6018578865 on ebay. dont have money for 9920 yet
Sylvester
12.10.2005, 09:55 PM
the link didnt work, http://cgi.ebay.ca/ws/eBayISAPI.dll?ViewItem&item=6018578865&ru=http%3A%2F%2Fsearch.ebay.ca%3A80%2Fsearch%2Fsea rch.dll%3Fcgiurl%3Dhttp%253A%252F%252Fcgi.ebay.ca% 252Fws%252F%26fkr%3D1%26from%3DR8%26satitle%3D6018 578865%26fvi%3D1 , if i were you i would just save up for a better controller, its better to buy somthing once, other than twice.
nbcaznmaster
12.10.2005, 10:06 PM
same here man, save up!
mmdooley
12.10.2005, 10:41 PM
yeap, It's only 30 amp. no good. I already learned this lesson.
tyrewq
12.11.2005, 12:44 AM
Originally posted by mmdooley
yeap, It's only 30 amp. no good. I already learned this lesson.

what happened? did the motor just not turn?
coolhandcountry
12.11.2005, 07:58 AM
It is not the motor you need to worry about. The motor is going to try to draw as many amps as it needs. The esc will be over loaded. This will cause more heat and stress until the smoke rolls.
MetalMan
12.11.2005, 11:35 AM
That controller probably wouldn't even work well in a car application, and that is besides the point that it won't handle the 8s without being completely damaged.
joostin420
12.12.2005, 10:04 AM
i run a schulze 12.97fe controller w/ my Hacker b50 8L and it works great in my TXT-1. just a note; i run a fan over all my controllers - brushed or brushless.

justin