New Anodized RCM Muggy Mount -
05.17.2010, 12:25 AM
Just a bit of feed back on the new anodized mount I installed today - Looks like the bearing hole needs to be opened up to account for anodizing. I had to actually take it all the way down to bare metal to get it to fit (used the new slipperential). This is my second Muggy mount, the first was not anodized and fit perfectly on the slipperential. Hopefully, the slight slop it has now (after I used my dremel with a sanding drum on it) wont affect longevity.
Other than that, it looks really good!
Losi 8T 1.0, Savage Flux - XL style, LST XXL, Muggy, 3.3 E-Revo Conversion and sitting outside 425hp, 831 Tq Dodge Ram Turbo Diesel. It SMOKES
Interesting - this is definately NOT the case with any one I have seen. I know that the holes are pretty true, so if the bearing is even slightly out of alignment it will appear as though it doesn't fit, but every one I just test fit(after reading, I checked a handful of the remaining stock), the bearing presses in perfectly(slight drag, but no excess force required to install). I do apologize if you got a tight bearing hole, but I assure you that it is a very rare occurrence and not indicative of the anodized mount, as the Muggy mounts have been anodized for a while now. :)
Last edited by RC-Monster Mike; 05.17.2010 at 10:05 PM.