RC-Monster Forums  
RC Monster

Go Back   RC-Monster Forums > Search Forums
Reload this Page Search Results

Page 1 of 20 1 2311 Last »
Showing results 1 to 25 of 500
Search took 0.04 seconds. Search: Posts Made By: snellemin
Forum: General Discussion 05.23.2019, 10:03 AM
Replies: 29
Views: 31,213
Posted By snellemin
I have a few RC stuff left. Lost almost all my...

I have a few RC stuff left. Lost almost all my belongings in 2017 Houston massive flood. We went through hard times for a long time, but all that is behind us. I'm into portable audio now. My...
Forum: General Discussion 05.03.2019, 01:06 PM
Replies: 29
Views: 31,213
Posted By snellemin
I snap. I too haven't been here in a while.

I snap. I too haven't been here in a while.
Forum: Brushless 11.02.2016, 12:17 PM
Replies: 1
Views: 4,450
Posted By snellemin
check out this old post. Aveox rotor...

check out this old post. Aveox rotor (http://www.rc-monster.com/forum/showthread.php?t=31047)
Forum: Novak 06.13.2016, 07:39 PM
Replies: 3
Views: 24,091
Posted By snellemin
Novak closed its doors

Saw on FB that Novak closed it's doors after 38 years.

Bummer.


Posted on FB:

Novak Electronics started in 1978, in true American dream fashion, right in Bob's living room with is family....
Forum: General Electric 03.22.2016, 12:25 PM
Replies: 97
Views: 59,702
Posted By snellemin
Thanks man.

Thanks man.
Forum: General Electric 03.21.2016, 05:03 PM
Replies: 97
Views: 59,702
Posted By snellemin
I cleaned up the wiring a bit on my bike. ...

I cleaned up the wiring a bit on my bike. Shortened the phase wires and did some serious crimping on those connectors. The thin insulation on the Cromotor phase wires had slits in them. I'm...
Forum: General Electric 03.08.2016, 07:48 PM
Replies: 97
Views: 59,702
Posted By snellemin
Sweet man. Post up some pics of the bike.

Sweet man. Post up some pics of the bike.
Forum: General Discussion 03.02.2016, 04:05 PM
Replies: 112
Views: 145,675
Posted By snellemin
Reading this and laughing:lol::mdr:

Reading this and laughing:lol::mdr:
Forum: Castle Creations 02.22.2016, 01:07 PM
Replies: 2
Views: 4,523
Posted By snellemin
Controlling a Castle Creations Controller via PC and Arduino

I saw this on a different forum. Thought it was pretty nice what these coulombmotorsport guys are doing with Castle products.

VajByNwH0aM
Forum: Castle Creations 02.16.2016, 03:36 PM
Replies: 25
Views: 15,642
Posted By snellemin
I'm liking the capbank assembly.

I'm liking the capbank assembly.
Forum: Brushless 02.12.2016, 05:17 PM
Replies: 7
Views: 9,824
Posted By snellemin
wow man. Nude shots!!! I'm not too crazy about...

wow man. Nude shots!!! I'm not too crazy about those loose coil winding in that motor.
Forum: General Electric 02.01.2016, 03:29 PM
Replies: 97
Views: 59,702
Posted By snellemin
Below are my settings with the Sabvoton...

Below are my settings with the Sabvoton controller. With 18s lipo I still hit 50mph with the flux weaking enabled. Before it took me 21s lipo to do so.
...
Forum: General Electric 01.17.2016, 07:00 PM
Replies: 97
Views: 59,702
Posted By snellemin
Finally getting around installing the Sabvoton. ...

Finally getting around installing the Sabvoton.

http://i189.photobucket.com/albums/z240/snellemin/Raptor/A7CD2BE8-5225-4D81-9037-723F5CEE1617.jpg...
Forum: General Electric 01.15.2016, 05:51 PM
Replies: 97
Views: 59,702
Posted By snellemin
I relocated the controller to the topside on the...

I relocated the controller to the topside on the inside of the battery box. This way I can lay down all the batteries. Well it worked for a bit and controller died on me. I'm sending the ESC in...
Forum: General Electric 09.01.2014, 11:05 PM
Replies: 0
Views: 8,164
Posted By snellemin
Build me a battery pack out of 18650

Build me a battery pack from a bunch of leftover 18650 batteries. Took a while to put together and balance out. I wired it up as two 8s packs in 4p config. I don't have a battery welder, so I just...
Forum: General Electric 08.30.2014, 02:25 AM
Replies: 97
Views: 59,702
Posted By snellemin
I installed my old 300lbs Titanium spring. Bike...

I installed my old 300lbs Titanium spring. Bike rides lower and can lean a bit lower in turns. Nice and comfy on the road and the Michelin's roll smoother vs the Crazy Bob's.

Vid of me climbing...
Forum: General Electric 08.25.2014, 12:14 PM
Replies: 97
Views: 59,702
Posted By snellemin
This is from my ride into work. I'm not missing...

This is from my ride into work. I'm not missing the 21s lipo setup at all. 18s still has plenty of speed and acceleration.
...
Forum: General Electric 08.25.2014, 01:33 AM
Replies: 97
Views: 59,702
Posted By snellemin
So instead of going with the moto rear wheel, I...

So instead of going with the moto rear wheel, I swapped over to my old Michelin's tires that was on my EVG bike. Big difference in how much better they ride vs the Crazy Bob's. Less rolling...
Forum: General Electric 08.25.2014, 01:32 AM
Replies: 97
Views: 59,702
Posted By snellemin
Got me some Tektro E-sub brakes. The calipers...

Got me some Tektro E-sub brakes. The calipers look well made, but these have small brake pads. The brake levers look like quality stuff. Maybe swap over to TRP 4 piston calipers with the brake...
Forum: General Electric 07.26.2014, 11:47 AM
Replies: 97
Views: 59,702
Posted By snellemin
I rearrange the battery setup and cleaned up the...

I rearrange the battery setup and cleaned up the wiring. I'm happy with the headlight, so I'll make that to a permanent setup and soon wire it up the main battery pack.
I did get to fit a 42T chain...
Forum: General Electric 07.21.2014, 04:31 PM
Replies: 97
Views: 59,702
Posted By snellemin
Here is build list of another forum member on...

Here is build list of another forum member on Endless-sphere. He goes by the name of offroader.


His total build price was around $5,678 USD.

Torque Raptor Motorcycle Frame kit = $1,528
24...
Forum: General Electric 07.21.2014, 04:28 PM
Replies: 97
Views: 59,702
Posted By snellemin
It is Mike. 40Mph comes in a hurry. Going from...

It is Mike. 40Mph comes in a hurry. Going from 30->40mph is very responsive, yet smooth. Cruising around at 48mph is no problem. I have around 1Kwh of battery capacity and that is plenty for me...
Forum: General Electric 07.21.2014, 03:42 PM
Replies: 97
Views: 59,702
Posted By snellemin
Reprogrammed the controller to 200A phase and 91A...

Reprogrammed the controller to 200A phase and 91A battery current. Tweaked the throttle setting in the CA and now have a nice smooth powerful setup that rides very nice on the streets. CA recorded a...
Forum: General Electric 07.17.2014, 12:34 PM
Replies: 97
Views: 59,702
Posted By snellemin
Finally got around to installing one of my fav...

Finally got around to installing one of my fav bike lights. Runs off 2s4p samsungs 18650's.



http://i189.photobucket.com/albums/z240/snellemin/Raptor/20140717_145959002_iOS.jpg...
Forum: General Electric 07.15.2014, 02:08 AM
Replies: 97
Views: 59,702
Posted By snellemin
So I went back to the 203mm rotors. I'll be...

So I went back to the 203mm rotors. I'll be changing the front caliper to Marta FR one of these days, which is slightly bigger and uses the same brake pads. I used my poor man machining skills and...
Showing results 1 to 25 of 500
Page 1 of 20 1 2311 Last »

 
Forum Jump


RC Monster




Powered by vBulletin® Version 3.8.1
Copyright ©2000 - 2021, Jelsoft Enterprises Ltd.
vBulletin Skin developed by: vBStyles.com

Contact Us - RC-Monster Store - Archive - Top