View Single Post
Old
  (#17)
MTBikerTim
Yip Yip Yip...
 
MTBikerTim's Avatar
 
Offline
Posts: 1,489
Join Date: Aug 2007
Location: Australia
02.22.2009, 09:25 PM

Quote:
Originally Posted by 93firebird View Post
Owning a Cen genesis and another Cen product, I'm not quite sure why you chose their diffs for the project. Just look on RCU and you will see all the problems ppl have with them.
I think the cen diff issues all stem from the **** house cen diff housing. The plastic savage cases seem to be strong enough to hold them together. I have been running the cen diffs in my brushless savage on 6s and 80mm medusa (R.I.P) and have sheared a drive pin holding the drive cup to the tranny but the diffs are fine.

I would also recommend the X casings for this mod. Bearing sizes would be different for the flux but i'm sure it could still be done.


Savage: FLM Conversion, 6s, MMM, CC 1520.
Mini-T Pro: Micro Pro 6800kv, Lipo, HS-81mg, Dirt Hawgs
M18MT: Quark 33A, Y22S 6000kv, FP 2s Lipo
LRP S8-BX: RC-M Conversion, Tekin RX8 B1600KV, 6S.
  Send a message via MSN to MTBikerTim  
Reply With Quote