View Single Post
Old
  (#67)
Topspeedtimmy
trick mad power (tmp)
 
Topspeedtimmy's Avatar
 
Offline
Posts: 102
Join Date: Nov 2007
Location: NE
07.07.2008, 02:19 PM

I have this old Antec 250w PS, but the voltage is 11.12v with no load and it goes below 11v when theres more than 15w load on the 12v wires. It's rated for 8A on the 12v rail. I don't want to spend any money on this piece of junk (especially since its only 96w), so is there any appropriate resistors I could take out of another circuit board from something else?


The timmy - Revo 3.3 MM 9XL 4s , Rustler MM 4600 3s
The ferty - Dual velineon Revo 3s, Rustler velineon 3s
   
Reply With Quote