View Single Post
Old
  (#9)
RC-Monster Mike
Site Owner
 
RC-Monster Mike's Avatar
 
Offline
Posts: 4,915
Join Date: Nov 2004
Location: PA
04.26.2016, 09:37 AM

That is definitely not the stock rear diff case - I propose that the issue is likely in the other part, as I am certain my cnc machine didn't simply decide to place the holes incorrectly this one time after making the same part for years. Maybe there is something else in the way? I see the mis-alignment in the picture, but I am certain the plate is the same as every other lower plate I've made since making this kit the 1st time several years ago.
   
Reply With Quote